Keywords
friction
strain paths
failure
FE simulation
How to Cite
Abstract
This paper presents the results of numerical and experimental investigations on the influence of friction on failure location in Nakajima formability tests. Finite element (FE) simulations were performed using commercial explicit dynamic FE code. The numerical results obtained from the FE simulation were compared with experimental data from Nakajima tests. A 3D digital image correlation system ARAMIS was used in experiments. The location of failure on the sample was detected depending on friction conditions. The studies confirmed that the crack location near the centre of the specimen as required by the ISO standard could be obtained for low values of the friction coefficient. The numerical simulation combined with the inverse analysis was used to estimate a real value of the friction coefficient in the Nakajima formability test.
References
2. Lumelskij D. et al.: Detection of strain localization in Nakazima formability test – experimental research and numerical simulation, Procedia Eng., 183 (2017) 89-94.
3. STN EN ISO 20482. Metallic materials – Sheet and strip – Erichsen cupping test, 2003.
4. STN EN ISO 12004-2. Metallic materials – Sheet and strip – Determination of forming limit curves. Part 2: Determination of forming-limit curves in the laboratory, 2008.
5. Larsson M., Mattiasson K., Sigvant M.: Some observations on failure prediction in sheet metal forming, 6h European LS-DYNA Users’ Conference, 2007, pp. 93-102.
6. Situ Q., Jain M, Metzger D.: Determination of forming limit diagrams of sheet materials with a hybrid experimental-numerical approach, Int. J. Mech. Sci., 53 (2011) 707-719.
7. Slota J., Jurcisin M., Spisak E. et al.: Experimental FLC determination of high strength steel sheet metal, Acta Metall. Slovaca, 18 (2012) 200-209.
8. Mattiasson K., Jergéus J., DuBois P.: On the prediction of failure in metal sheets with special reference to strain path dependence, Int. J. Mech. Sci., 88 (2014) 175-191.
9. Pilthammar J., Sigvant M., Kao-Walter S.: Introduction of elastic die deformations in sheet metal forming simulations, Int. J. Solids Structures, 131 (2017) in press, https://doi.org/10.1016/j.ijsolstr.2017.05.009.
10. Hol J., Meinders V.T., Geijselaers H.J.M. et al.: Multi-scale friction modeling for sheet metal forming: The mixed lubrication regime, Tribology Int., 85 (2015) 10-25.